Best Tool For Removing Carpet Tack Strips

Then tap it with a hammer until the tack strip pops up.

Best tool for removing carpet tack strips. Rust can bleed through the carpet creating stains on the surface. Begin at the top of the stairs. At those points slide a pry bar under the tack strip. After pulling up your carpet you will most likely have tack strips left around the perimeter of the room.

If you are pulling up carpet from stairs. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. Carpet tack strips can usually remain in place but look for rust rot or other damage.

Roll or fold the strip secure with duct tape and remove it from the room. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. To remove tack strip just pop it up with a flat pry bar. Reinsert them beside the next nail on the tack strip and pop that nail out the same way.

Once the carpet is removed locate the nails which attach the tack strips to the floor. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. Wide to tuck the edge of the carpet down against the baseboard. Press the pry bar in order to begin lifting the tack strip.

The installer needs a gap at least 1 4 in. Pick somewhere to start either a corner or a break between two tack strips. Continue like this until you have.